A belt-positioningbooster seat should be used if the shoulder belt rests in front of the child's face or neck, or if the lap belt does not fit snugly on both thighs, or if the thighs are too short to let the child sit all the way back on the seat cushion when the lower legs hang over the edge of the seat cushion. If more than five seconds pass between pressing numbers, enter the code again. Seating and safety restraints ² Put the safety belt in the automatic locking mode. ² A disc with format and dimensions not within industry standards is inserted. Safety belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted. Your vehicle is equipped with a special feature that allows you to access clock mode when the vehicle is not running. Turn control to raise or lower volume.
The parking brake is not recommended to stop a moving vehicle. Belt minder chime Sounds intermittently to remind you to fasten your safety belts. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail. Press the control up for higher fan speed or down for lower fan speed. Dolbyt noise reduction system is manufactured under license from Dolbyt Laboratories Licensing Corporation. To raise the height of the shoulder belt, slide the height adjuster up.
Brake system warning Momentarily illuminates when the! How does the personal safety system work? To tighten the belt, pull the loose end of the belt through the tongue until it fits snugly across the hips. Illuminates when the oil pressure falls below the normal range. ² Tighten very loose tapes by inserting a finger or pencil into the hole and turning the hub. Failure to follow these instructions may increase the risk of injury in a collision. If uncomfortableº you are uncomfortable - try different positions for the safety belt upper anchorage and seatback which should be as upright as possible; this can improve comfort. The top of the high intensity area should touch the horizontal reference line, if not, the beam will need to be adjusted. The system is ready to arm whenever the key is removed from the ignition.
You will have all the service and repair information you could ever need for your 2001 Ford Taurus. The safety belt needs to be latched for a minimum of 3 seconds before belt minder is disabled. One through your dealer and the second with a door lock sequence using the following instructions: 1. ² Floor and defrost -Distributesoutside air through the windshield defroster ducts and the floor ducts. Press and hold a memory preset control until the sound returns, indicating the station is held in memory on the control you selected. Press to eject the magazine.
Allow the safety belt to retract to remove any slack in the belt. ² Place seat back in upright position. Install the bulb socket into the lamp assembly by rotating it clockwise. Tune adjust The tune control works in radio mode. The fact that the pretensioners or air bags did not activate in a collision does not mean that something is wrong with the system. If you do not hold the brake pedal down, your vehicle may move unexpectedly and injure someone. The purpose of the Belt Minder is to remind occasional wearers to wear safety belts all of the time.
These sensors provide the ability to tailor the air bag deployment based upon how close the driver's seat is to the steering wheel and whether or not the safety belts are fastened. The display will show and a bar graph to indicate manual fan operation and relative speed. During the first 1 600 km 1 000 miles of driving, vary speeds frequently. The temperature will remain unchanged and air will be cooled based on the selected temperature. However, the air cannot be cooled below the outside temperature because the air conditioning does not operate in this mode. Also illuminates if the parking brake is engaged.
Placing objects on or over the air bag inflation area may cause those objects to be propelled by the air bag into your face and torso causing serious injury. Remove the cowl vent screen. Inserting a tape Push only slightly when inserting a cassette tape with the open edge to the right. If equipped with a moon roof, the map lamps are located on the moon roof control panel. Replace the four clips located on the cowl vent screen. Route the child safety seat tether strap over the back of the seat.
If it comes on after the engine is started, one of the engine's emission control systems may be malfunctioning. This allows the tongue to unlatch from the buckle. Do not drive if you smell exhaust fumes. Replacement of the battery will not cause the remote transmitter to become deprogrammed from your vehicle. Loosen each wheel lug nut one-half turn counterclockwise but do not remove them until the wheel is raised off the ground. Never adjust the accelerator and brake pedal with feet on pedals or while the vehicle is moving. To avoid potential distraction and increased risk of injury or accident, Ford recommends you do not use the phone while driving.
Do not fill above this line. When refueling, after the light comes on, the amount of fuel that is added will be less than the advertised capacity since there is fuel still in the tank. For information on the safety belt minder chime, refer to the Seating and safety restraints chapter. ² Press the right side of the control to move to the next frequency up the band whether or not a listenable station is located there. The first track of the first disc will begin playing. Rather, it means the forces were not of the type sufficient to cause activation.
Do not pile cargo higher than the seatbacks to reduce the risk of injuring people in a collision or sudden stop. Lift the remote latch release on the left side of the compartment and fold the remaining floor panel until it latches. Mode selector control Controls the direction of the airflow to the inside of the vehicle. Turn control to raise or lower volume. Instrumentation Light is blinking: Engine misfire is occurring which could damage your catalytic converter. Controls and features To install the shade: 1.