He must keep this plan at the facility. Comment: The requirements of paragraph b of this section are satisfied if the facility or plant within which the active portion is located itself has a surveillance system, or a barrier and a means to control entry, which complies with the requirements of paragraph b 1 or 2 of this section. Generator's Name and Mailing Address Enter the name and mailing address of the generator. Copies of the manifest are not required for each transporter. Special requirements for incompatible wastes. Special requirements for incompatible wastes.
This information must be maintained in the operating record until closure of the facility. Special requirements for ignitable or reactive waste. Compatibility of waste with containers. Assessment of existing tank system's integrity. Standards: Closed-vent systems and control devices.
Availability, retention, and disposition of records. Instructions -- Continuation Sheet, U. If another mode in addition to the highway mode is used, enter the appropriate additional mode e. This paragraph will only apply until the State is authorized to permit such facilities under subpart A of Part 271 of this chapter. Inspections must be conducted at least once each month. D An immediate threat to human health, public safety, property, or the environment, from the known or suspected presence of , other explosive material, or an explosive device, as determined by an explosive or munitions emergency response specialist as defined in. The legend must be written in English and in any other language predominant in the area surrounding the facility e.
Documentation of a waste determination by knowledge is required. Therefore, the provisions of §§ 262. Subpart C -- Pre-Transport Requirements §262. Note: International Shipments -- Transporter Responsibilities. This waste must be separated and protected from sources of ignition or reaction including but not limited to: open flames, smoking, cutting and welding, hot surfaces, frictional heat, sparks static, electrical, or mechanical , spontaneous ignition e. Transporter 1 Company Name Enter the company name of the first transporter who will transport the waste. Approved by the Office of Management and Budget under control number 2050-0035 §262.
At a minimum, the analysis must be repeated: i When the owner or operator is notified, or has reason to believe, that the process or operation generating the hazardous wastes, or non-hazardous wastes if applicable under 264. A miscellaneous unit must be located, designed, constructed, operated, maintained, and closed in a manner that will ensure protection of human health and the environment. Containment and detection of releases. For disposal facilities, the location and quantity of each hazardous waste must be recorded on a map or diagram that shows each cell or disposal area. This includes time for reviewing instructions, gathering data, and completing and reviewing the form. This emergency coordinator must be thoroughly familiar with all aspects of the 's , all and activities at the , the location and characteristics of waste handled, the location of all records within the , and the layout.
If the generator does not supply the information, and the owner or operator chooses to accept a hazardous waste, the owner or operator is responsible for obtaining the information required to comply with this section. Federal regulations require generators and transporters of hazardous waste and owners or operators of hazardous waste treatment, storage, and disposal facilities to use this form 8700-22 and, if necessary, the continuation sheet Form 8700-22A for both inter and intrastate transportation. In addition, this person must have the authority to commit the resources needed to carry out the contingency plan; 12 Develop, maintain and implement a plan to meet the requirements in paragraphs j 2 through j 6 and j 9 through j 10 of this section; and 13 Maintain records documenting compliance with paragraphs j 1 through j 12 of this section. Each Continuation Sheet will record the names of two additional transporters. General requirements for ignitable, reactive, or incompatible wastes. The and of are subject to the applicable permitting, procedural, and technical in through 270. Use of a mechanism for financial assurance of both closure and post-closure care.
However, the frequency should be based on the rate of deterioration of the equipment and the probability of an environmental or human health incident if the deterioration, malfunction, or operator error goes undetected between inspections. The facility must retain a copy for its records and then give the remaining copies of the manifest to the transporter to accompany the shipment. These apply to all , and of at these facilities after the effective date of these regulations, except as specifically provided otherwise in this part or part 261 of this chapter. Note: All of the above information except the handwritten signature required in item 16 may be preprinted. The owner or operator must conduct these inspections often enough to identify problems in time to correct them before they harm human health or the environment. The owner or operator may develop one contingency plan which meets all regulatory requirements. Definitions of terms as used in this subpart.
Definitions of terms as used in this subpart. These procedures must address proper design, construction, maintenance, and of units at the. Customs official at the point the hazardous waste leaves the United States in accordance with §263. Transporter ---- Acknowledgement of Receipt of Materials Enter the same number as identified in item 26. Transporter 2 Acknowledgement of Receipt of Materials Enter, if applicable, the name of the person accepting the waste on behalf of the second transporter.
Response to leaks or spills and disposition of leaking or unfit-for-use tank systems. The requirements and prohibitions that are applicable until a receives authorization to carry them out include all Federal program requirements identified in § 271. Personnel training records may accompany personnel transferred within the same company. Compliance with the hydraulic conductivity requirements must be verified by using in-situ testing on the constructed test fill. An extension of up to 30 days may be granted at the discretion of the Regional Administrator on a case-by-case basis.
If the consignment State does not supply the manifest form, then the manifest form may be obtained from any source. How to make user fee payments. Therefore, the provisions of 262. Standards: Open-ended valves or lines. The address must be the site address, which may differ from the company mailing address.