Combine that with a low seat height 28. Are You Ready to Ride? Multi carburetors not in sync. Fuses Make sure you have a full supply of spare fuses. The other inspection items are also very easy to do yourself; things like brake wear, throttle operation, brake lever slack, suspension travel, and cleaning the engine breather drain tube, are all very simple to do yourself and can save you a lot of money. Spin the wheel slowly and read the runout using a dial i ndicator.
Needle and seat stuck closed in the float bowl. A brake light that does not come on when the rear brake pedal is depressed can be caused by a faulty switch, air contamination in the brake line, or no continuity in the wiring at the switch. As an owner of the Honda Ruckus 2009 scooter, I have found that doing my own maintenance is very easy and saves me an awful lot of money. Drive a new right bearing squarely with the sealed side facing up until it is fully seated using the spe. If this is the case, you can try inflating the tire to see if it will hold air We strongly recommend that you replace, pressure. The Ruckus is not restricted like many 2-strokes. Vacuum line from the petcock to intake manifold cracked.
Good luck and have a wonderful day. The other big downside to the Ruckus is that its kinda slow. Parts that do not meet Honda's design specifications may cause damage to the scooter. Remove the throttle cable from the lower housing. Idle port, transfer ports, slow air jet clogged. Particle contamination in inlet fitting cavity.
During this period, avoid full-throttle starts and rapid acceleration. Rather, it would have been nice to have an engine with a removable cylinder so big bore kits that add serious power are an option. Taking Care of the Unexpected. Everywhere you go people ask where they can get one. Service on this machine is fairly simple. Used oil, gasoline, coolant, and Following are tips on how you can be an cleaning solvents contain poisons that.
Good luck and have a wonderful day. Air fuel mixture adjustment too lean. Faulty fuel pump or internal fuel line has pinholes. Recommended Fuses If something electrical on your scooter stops working, the first thing you should. Good luck and have a wonderful day.
However, if you decide to carry maximum weight capacity: any cargo, ride at reduced speeds and 220 lbs 100 kg follow these common-sense guidelines:. Good luck and have a wonderful day. Installation Installation can be done in the reverse 1 tab 2 fuel tank lid order of removal. This motor also features a number of technological advances. Idle adjusting screw set too low. As you wash, check for heavy grime. There are of course some things that are a bit harder to service, but this manual will take you through the first 8000 kilometers, and also allows you to do troubleshooting and repair of lots of other things.
You may want to check the recommended oil for your model. Good luck and have a wonderful day. Be careful, a broken bolt hazard is present. Disconnect the brake cable from the brake lever and remove the lever. The rear brake lock will not be applied if To operate, push the horn button.
The result is the traditional starter motor is eliminated saving weight, noise, cost and complexity. Keep the scooter as upright as possible. Loosen the lower fork pinch bolt and remove the fork tube from the steering stem. A clean plastic on your scooter. Return the dust cover to its normal position. Faulty fuel pump or internal fuel line has pinholes.