As you might know each series of car model has different dimensions - width, length, height, wheel base, and suspension which you can choose by picking out one of the available specs of the model you like. If excessive force is required for removal, check front disc brake rotor for lateral runout prior to installation. The recall began on April 18, 2014. The Cobalt ended production on June 23, 2010. Install front disc brake rotor and disc brake caliper. If axle nut has a cotter pin, never back off on nut to install. The key fob if applicable , should also be removed from the key ring.
The bearing races will need to be removed from the rotor to do this use a punch and hammer once the rotor is removed. Your main objective is to not have them come loose. Remove the hub extension and the brake caliper as well as the caliper adapter. A Pontiac version was sold primarily as the Pontiac G5 in Canada for its entire run where it was briefly known as the Pontiac Pursuit and later Pontiac G5 Pursuit , as well as the Pontiac G4 in Mexico for 2005-2006, and in both Mexico and the United States under the G5 name for 2007-2009. I'm not sure what year your car is but this could be the case.
If loosened, the retainer must be removed and a new one installed. Pack the wheel bearings with grease. Recall Date 2014-02-10 Description This defect can affect the safe operation of the airbag system. I torque mine to 100. Loosen the nut first, then remove nut from stud using the hex hold feature.
Install new rotor, then push the piston back into the caliper a little ways, or all the way if installing new pads. If necessary advance nut to install a new cotter pin. If wheel hub is disassembled, the assembly must be replaced. Note: Until the recall repairs have been performed, it is very important that customers remove all items from their key rings, leaving only the vehicle key. Use of these methods will damage bearing internal parts. Then tighten the nut and install the nut lock and a new cotter pin.
Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The following recall is due to extreme heat causing damage to the plastic fuel pump lines. All models have body-colored door handles and jewellike headlights and taillights. Remove all foreign material from knuckle bearing bore for correct seating of new wheel hub. In addition, the 2007 model year marked the introduction of a new 32-bit computer that replaced the 16-bit unit from 2006. Distinct interiors and wheels help in differentiating the models. Their torque holding ability or retention capability is diminished during removal.
Distinct interiors and wheels help in differentiating the models. Replace the outer wheel bearing, washer, and then the retaining nut. Torque the hub nut to 284 ft. Install new pads and install the caliper. The Cobalt is agile around town and stable enough on the highway, but you must pay attention to remain on course. All affected owners will receive another letter once parts are available.
Bolt in new hub assembly and torque bolts. An interim notification was issued to owners of 2007 and earlier models on March 10, 2014, informing them of the safety defect. You do not acquire ownership rights to any content, document or other materials viewed through the site. Now, pull the old rotor off of the spindle. This can be done using the old brake pad and a c-clamp to push the piston down. If I've helped, please vote! Around the same time, the Ford Freestyle became the Taurus X. Remove front disc brake rotor 1125.
Block the wheels to keep it from rolling as you work. Remove front disc brake rotor from wheel hub 1104 by pulling it off the lug bolt 1107. A power sunroof is optional. Torque the bolts to 38 ft. Remove wheel hub from front wheel knuckle.